First Aid (Continuation)

 

Dressings:

They are used to protect a wound and prevent infection, but also to allow healing.

A dressing should be large enough to totally cover the wound, with a safety margin of about 2.5 cm on all sides beyond the wound.

A sterile dressing may be used to control bleeding from a major wound or to absorb any discharge from a minor wound.

Burn gel dressing: instantly removes heat from a burn or scald, dissipating the heat and preventing the burn from progressing deeper into the skin tissue.

Bandages:

A bandage is used in combination with a dressing where a wound is present.

a)      Roller bandage is used to:

• hold a dressing in place on a wound

• maintain pressure over a bulky pad to control bleeding

• support an injured limb or joint

• apply pressure to a limb

Roller bandages are made from lightweight cotton, crepe or elasticized crepe, depending on the pressure to be achieved.

A lightweight cotton bandage is used to hold a dressing in place, whereas a crepe or elasticized crepe bandage is used for applying support or firm pressure to a soft tissue injury.

Basic steps to successful use of a roller bandage:

·         Bandage the part in the position of greatest comfort to the patient. Support the part adequately before starting to apply the bandage.

·         Hold the tightly rolled bandage with the ‘head’ of the bandage on top and wrap the ‘tail’ around the body part without unrolling more than a few centimetres at a time.

·         Begin with a locking turn to hold the start of the bandage securely under each following turn.

·         Work from the middle of the body or limb in an outwards direction.

·         Work from the narrowest part below the dressing and work upwards.

·         Ensure that each turn covers two-thirds of the previous turn.

·         Cover totally any dressing and padding used.

·         Finish with a straight turn at the end of the bandage.

·         Secure the bandage with a safety pin or adhesive tape. Avoid the use of metal clips because they are less secure and can fall out during activity.

Applying a roller bandage to the lower arm or leg:

·         Apply a dressing or padding over the affected area.

·         Start with a diagonal, locking turn below the dressing or padding to secure the dressing.

·         Continue up the limb, covering two-thirds of each previous turn.

·         Finish with a straight turn to secure the bandage and fasten it with a pin or adhesive tape.

Applying a roller bandage to the elbow or knee:

·         Apply a dressing or padding over the affected area.

·         Start with a full turn over the point of the elbow or knee to secure the bandage.

·         Make a second turn just below the first, exposing one-third of the initial turn over the point of the elbow or knee.

·         Make a third turn just above the first, again exposing one-third of the initial turn over the point of the elbow or knee.

·         Continue with one or two more turns alternately working from below to above the affected joint, until the dressing or padding is fully covered.

·         Avoid any extra turns that will cause pressure on the inside surface of the joint.

·         Finish with a full turn above the elbow or knee and secure the bandage with a safety pin or adhesive tape.

Applying a roller bandage to the hand or foot:

·         Apply a dressing or padding over the affected area.

·         Start with a diagonal, locking turn around the wrist or foot.

·         Carry the bandage across the back of the hand or foot to the base of the little finger or little toe and then make a complete turnaround the fingers or toes.

·         Make another turn across the back of the hand or foot from the fingers/toes to the wrist/ankle.

·         Repeat these turns working upwards with each turn until the dressing or padding is covered.

·         Finish with a circular turn around the wrist ankle and secure the bandage with a safety pin or adhesive tape.

 

b)      Triangular bandage is used as an arm sling or as a pad to control bleeding. It may also be used to support or immobilize an injury to a bone or joint or as improvised padding over a painful injury of broken bones and soft tissue injuries.

Sling

•           In the open form as a sling to support an upper body injury.

Broad-fold bandage

•           As a broad-fold bandage with the apex folded down to the base twice to immobilize a lower body injury.

Narrow-fold bandage

•           As a narrow-fold bandage with the broad-fold bandage folded in half to control severe bleeding, or for immobilization of a lower limb.

•           As a collar-and-cuff sling for an upper body injury.

Pad

•           As a folded pad after the ends of the narrow fold bandage have been brought into the center three times, and for use on a major wound or as padding.

 

Practical examples:

**Tying a reef knot with a triangular bandage

When using a triangular bandage it is important to use a reef knot to secure it in place. A reef knot is a flat knot that will not slip undone and, if correctly placed on the body, is comfortable for the patient.

1.         Wrap the left end of the bandage over and then under the right end to start the knot.

2.         Wrap the right end over and then under the left end to complete the knot.

3.         Pull the knot tightly from both sides to ensure that it will lie flat.

It is easy to untie a reef knot without jarring or hurting the patient. Simply choose two paired ends as they come out of the knot at one side. Then pull the ends apart steadily until two loops form and can be slipped off one end.

Arm sling

This sling is used to support a lower arm or hand injury and for rib or collarbone fractures.

•           Encourage the patient to hold the affected arm across the body in the position of greatest comfort.

•           First hold the bandage with the base running down the centre of the body and the point to the elbow on the affected side. Gently slip the top point under the supported arm and wrap it around the back of the neck until it rests on the shoulder of the affected side.

•           Lift up the lower point and take it to meet the upper point at the side of the neck on the affected side.

•           Use a reef knot (see above) to tie the ends together just above the collarbone to avoid any pressure on the back of the neck.

•           Adjust the sling so that the fingertips are clearly visible and then bring the point forward and fasten it to the sling with a safety pin.

•           Finally, check the circulation in the fingers and compare the tissue colour with the fingertips on the unaffected arm. If there are any signs of an impaired circulation, loosen or remove the sling and any underlying bandages.

Elevation sling

This sling is used for an arm or finger injury where the patient needs the hand and arm to be held in an elevated position.

•           Encourage the patient to hold the affected arm across the body with the fingers pointing to the opposite shoulder tip.

•           First hold the bandage with the base running down the center of the body and the point to the elbow on the affected side. Gently place the bandage over the supported arm and carry the top end around the front of the neck until it rests on the unaffected shoulder.

•           Gently wrap the lower half of the bandage along the affected arm. Carry the free end of the bandage from the elbow across the back to the opposite shoulder tip.

•           Gently twist the top point around the fingers, but avoid placing pressure on any injury. Tie the two ends together with a reef knot (see above) and place it just above the collarbone to avoid any neck pressure.

•           At the point of the elbow smooth the loose fabric forwards along the arm under the sling. Secure the sling firmly at the elbow with a safety pin or tape.

Collar-and-cuff sling

This sling is used to hold the lower arm and hand in an elevated position where a full elevation sling is either not required, or for patient comfort in very hot weather. The sling is made with a narrow fold bandage used as a clove hitch.

•           Make a clove hitch with two large loops of the bandage. One loop is made with the bandage end pointing upwards and the other end pointing downwards.

•           Fold the two loops inwards towards the middle, ensuring that both ends are trapped between the loops.

•           Encourage the patient to hold the affected arm across the body with the fingers pointing to the opposite shoulder tip. Then gently slide the two loops over the hand and lower arm with the ends hanging downwards.

•           Carry the two bandage ends up on either side of the limb and around the patient’s neck. Adjust the bandage so that it is possible to tie a reef knot  just above the collarbone on one side to avoid any pressure on the neck.

•           The knot may be placed on either side of the neck depending on the location of the injury and the comfort of the patient.

 

c)      A tubular gauze bandage is used to retain a dressing on a finger or toe.

Micro porous tape: secures bandages and dressings to skin. Should not leave a sticky residue, hypoallergenic and can be used long-term, without fear of skin irritation. Has an adhesive sticks to skin, underlying tape, or directly to dressing materials.

 

Wound cleaning wipes: cleanses the wounds and the surrounding areas to properly care for an injury so that the healing process can begin.

Resuscitation shields:

Resuscitation face shield: protect the rescuer from infection whilst performing mouth-to-mouth resuscitation

Foil thermal blankets:

·         Retains body heat in emergency first aid situations

·         Use for treatment of shock and hypothermia

·         Protects against cold, rain, heat and wind

 

REFERENCES

St. John’s first aid manual.